Nordmeyer – DSB 2/10

Drilling rig Nordmeyer, type DSB 2/10, s/n: 1974, year 2006

Drilling depth up to: 400m
Installed power: 176 HP
Drilling rig can use more then 10 method of drilling
Patented construction of the mast

Maximum force of the mast – 12.000 daN
Feed length – 5,80 m
Length of mast – 8,36 m
Feed force/ pull back force – 10.000 daN
Pull down force – 5.000 daN
Crown of mast-winch (pull back force 1.900 daN), 50 meters of rope

Double rotary head, type: KSP 7.8.2, sn: 0724-
I gear: -torque 1500 daNm, speed 0-62 rpm
II gear: -torque 750 daNm, speed 0-120 rpm
Quick manual and automatic mechanism for unscrew and grab rods/pipes
Additional 2 cylinder for wrenching / pull up pipes from bore hole

Drill head movable in 4 positions

3x mud pumps:
– Centrifugal CAPRARI pump with two rotors, nominal working pressure: 16 bar, flow: 1600 l/min
– Screw pump WANGEN, nominal working pressure 20bar, flow 730l/min
– Three piston pump CAT2520, nominal working pressure 50bar, flow: 90l/min
All pump are powered and control by hydraulic system
Perfec solution for all geology.
Year of construction: 2006
Working hours: 15500 mth
VIN: 1974

Maximum size of casing pipe in double rotary head preventer: 178mm

Maximum size of casing/bits diameter:

– Straight Flush Rotary Drilling
A) direct flush rotary drilling up to
dia. 17½” = dia. 445 mm
B) reverse circulation drilling with sludge
pump or air-lift drilling
with compressor up to drilling dia. 680 mm
in front of the mast, resp. up to dia. 1000 mm
below the mast.
– Down-The-Hole-Hammer Drilling with stand-by compressor up to drilling dia. 17½” = dia. 445 mm

Condition:
Machine always serviced in Nordmeyer service station.
Bought from first owner.
GOOD WORKING CONDITION